Whole-house PEX and copper repipes for older Mississippi homes
Repiping in Tupelo, MS Without Tearing Your House Apart
If your Tupelo home still runs on galvanized steel or failing polybutylene, repiping Tupelo MS is the permanent fix. We replace every supply line from the meter to the last fixture, usually in two to four days, with drywall cuts kept small and patched before we leave. One call, one crew, one warranty.
Live phone supportUpfront optionsBacked workmanship
What's included
What a Whole-House Repipe Includes
Every repipe we quote includes the full supply-side replacement, not just the visible runs. Here is what is covered on a standard Tupelo repipe, and what we handle as an add-on if you want it done at the same time.
Full Supply Line Replacement
We replace every hot and cold supply line from the main shut-off valve to each fixture. That includes runs through the attic, crawlspace, and interior walls. No old pipe is left in service, so you are not back to chasing leaks in a year.
New Shut-Off Valves
Every fixture gets a new shut-off valve, and we replace the main valve too. Old gate valves seize up and break when you need them most. New quarter-turn valves let you isolate any fixture without shutting down the whole house.
New Supply Lines and Fittings
We install new supply lines at every toilet, sink, and appliance, along with new pipe fittings throughout. Solder joints on copper and press fittings on PEX are done to Uniform Plumbing Code standards and pressure-tested before we close any wall.
Water Heater Tie-In
We reconnect your existing water heater to the new pipe and replace the shut-off valve and flex connectors. If your Rheem, Bradford White, or AO Smith tank is near the end of its life, we can swap it during the repipe so everything is new at once.
Pressure Test and Drywall Patching
We pressure-test the entire system before closing walls, then patch the drywall cuts we made. Patches are left ready for paint. You do not need to hire a separate drywall contractor unless you want a full repaint of the affected rooms.
Service overview
What Repiping Tupelo MS Actually Involves
Repiping Tupelo MS is a full replacement of your home's water supply lines, not a patch job on one leaky section. We cut out the old galvanized, copper, or polybutylene pipe and run new PEX piping or copper piping from the main shut-off valve through the attic, crawlspace, or walls to every faucet, toilet, shower, and water heater. Old pipe fittings, corroded shut-off valves, and brittle supply lines all come out at the same time. When we finish, the system is code-correct under the Uniform Plumbing Code and ready for decades of service.
Most of the homes we repipe in Tupelo were built between 1940 and 1985, and their original pipes are simply worn out. Galvanized steel rusts from the inside, which is why you see brown water and low water pressure at the shower. Polybutylene gets brittle and splits without warning. If you have had two or more pinhole leaks in a year, or a slab leak under the foundation, whole house repiping Tupelo Mississippi is cheaper than chasing repairs. We also handle repiping services Tupelo MS for rental property owners who are tired of after-hours calls.
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.
The service timeline
How Our Repiping Process Works
The process flexes to the condition, but these checkpoints keep decisions clear.
On-Site Assessment
We walk the house, identify every fixture, and check the main shut-off valve, water heater, and crawlspace or attic routing. If you have a slab leak, we use leak detection equipment to map the line before we quote. You get a flat price the same visit, usually within 60 to 90 minutes.
Material and Route Plan
We decide between PEX piping and copper piping based on your water chemistry, budget, and how the house is framed. You approve the route before we cut anything. We mark fixture locations, plan drywall cuts, and schedule the water shut-off window so you are not without water longer than necessary.
Repipe Day One and Two
The crew arrives with pipe cutter, press fitting tool, and soldering torch. We run new lines through the attic or crawlspace, tie in the water heater, and replace shut-off valves and supply lines at each fixture. Most single-story homes take two days. Two-story homes with attic runs take three to four.
Pressure Test and Flush
Before any wall goes back together, we pressure-test the entire system and flush every line. We check for leaks at every fitting, then run hot water to confirm the water heater is feeding correctly. If something fails the test, we fix it before you ever see it.
Walkthrough and Warranty
We walk the house with you, show you the new main shut-off, and explain what to watch for in the first week. Drywall patches are left ready for paint. You get a workmanship warranty on the install and manufacturer coverage on the pipe and fittings. Then we get out of your way.
Tools & methods
Tools and Methods We Use on Every Repipe
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Press fitting tool
Connects PEX and copper fittings without an open flame. Faster and safer inside walls, especially in older Tupelo homes with dry framing and insulation nearby.
Pipe cutter
Makes clean, square cuts on copper and PEX so every fitting seats properly. Square cuts are the difference between a joint that holds for decades and one that weeps in a year.
Soldering torch
Used for copper repipes where sweat fittings are the right call. We keep a fire watch and use heat shields when working near framing, which is standard practice on older homes.
Leak detection equipment
Finds slab leaks and hidden line failures before we quote. Knowing exactly where the problem is keeps the repipe scope accurate and prevents surprise charges.
Sewer camera
Inspects waste lines while walls are open. If we find root intrusion or a cracked sewer line during a repipe, we can flag it before it becomes a separate emergency.
RIDGID and Milwaukee diagnostic tools
Used for pressure testing and moisture checks. We verify the system holds pressure before closing walls, so you never wonder whether a hidden joint is leaking.
Use cases
When Tupelo Homeowners Call Us for a Repipe
These examples show how the service framework adapts rather than forcing every call through one repair.
Bel Air Polybutylene Replacement
A 1978 Bel Air home had polybutylene pipe and the owner's insurer had flagged it. Two fittings had already failed inside walls, causing drywall damage in the hallway and a bathroom. → We removed all polybutylene and installed new PEX piping in three days, including new shut-off valves at every fixture. The drywall was patched and ready for paint. The insurer accepted the documentation and removed the flag.
South Tupelo Slab Leak Reroute
A South Tupelo home had two slab leaks repaired in eighteen months, each requiring concrete cutting and floor repair. The homeowner was facing a third repair and considering a full repipe instead. → We abandoned the under-slab lines and rerouted new PEX piping through the attic in four days. No concrete was cut, the floors stayed intact, and the home has had no leaks since the repipe was completed.
Know when
6 Signs Your Tupelo Home Needs Repiping
A Tupelo home needs repiping when the supply system fails as a whole, not in one spot. These 6 signs point to a repipe over another repair.
Repeat Leaks
Two or more leaks on different runs within a year.
Low Pressure Everywhere
Weak flow at every fixture from corrosion inside galvanized pipe.
Discolored Water
Brown or rust-colored water from several taps on the first draw.
Known-Problem Pipe
Galvanized steel or gray polybutylene supply lines.
Home Built Before 1980
Original supply lines past their reliable service life.
Insurance or Sale Pressure
An insurer or buyer requires replacement before coverage or closing.
Route planning
How We Repipe Slab and Crawlspace Homes
Tupelo homes sit on 2 foundation types, and the foundation decides the pipe route. Both routes keep drywall openings small and planned.
Crawlspace homes
- New lines run under the floor through the crawlspace
- Short vertical drops into each fixture wall
- Fewest drywall openings of any repipe
Slab-on-grade homes
- Old lines under the slab are abandoned, not dug up
- New PEX runs through the attic and down interior walls
- No concrete cutting and no slab leaks on the new system
Problems we solve
Problems a Repipe Solves for Tupelo Homes
Most repipes start with a symptom the homeowner has been tolerating for months. Here are the four we see most often in Tupelo, and what happens if you keep putting them off.
Brown or rust-colored water from the tap
We replace the galvanized pipe with PEX or copper, flush the system, and confirm clear water at every fixture before we leave. Most homeowners see the difference the first time they run the tap after the repipe.
Low water pressure at upstairs fixtures
New PEX piping restores full flow to every fixture. We size the lines correctly for the fixture count, so pressure stays strong even when the shower and dishwasher run at the same time.
Repeated pinhole leaks in copper pipe
We remove the failing copper and install new pipe throughout. If your water chemistry is aggressive, we can recommend PEX piping, which is not affected by the same pitting process, and install a water softener if hardness is the cause.
Polybutylene pipe that could split without warning
We remove every foot of polybutylene and replace it with PEX or copper. You get a documented repipe that satisfies insurers and home inspectors, and you stop worrying about a wall full of pipe that is past its service life.
Pricing process
What Repiping Costs in Tupelo
$4,500 - $12,000 depending on scope
Home size and layout
Square footage and the number of stories drive the amount of pipe and labor. A 1,200 sq ft single-story home takes far less time than a 2,800 sq ft two-story with bathrooms on both floors.
Fixture count
Every sink, toilet, shower, and appliance connection adds a run and a shut-off valve. A home with three bathrooms and a kitchen costs more to repipe than a one-bath house, even at the same square footage.
Pipe material
PEX piping is faster to install and costs less than copper piping. Copper repiping Tupelo MS jobs run higher because of material cost and the extra labor for soldered fittings. We quote both so you can compare.
Customer reviews
What Tupelo Homeowners Say
★★★★★
“Our 1952 house had galvanized pipe and we were getting brown water every morning. TupelomsPlumbing.com repiped the whole house in three days with PEX. They kept the drywall cuts small and patched everything before they left. Water pressure upstairs is better than it has ever been. Worth every dollar.”
★★★★★
“We had three pinhole leaks in eighteen months and finally said enough. The crew quoted a flat price, showed up on time, and finished in two days. They replaced every shut-off valve and supply line too. No more leaks, no more stained ceiling. I wish we had done this two years ago.”
★★★★★
“I own two rental houses near downtown and both had polybutylene pipe. The repipe took four days total across both units and the tenants barely noticed. The plumbers were licensed, polite, and cleaned up after themselves. I have not had a single leak call since. That is the whole point.”
How much does repiping cost in Tupelo MS?
Most whole-house repipes in Tupelo run $4,500 to $12,000 in 2026, depending on square footage, fixture count, and whether the lines run through a crawlspace or attic. A single-story 1,500 sq ft home with eight fixtures usually lands near the lower end. Two-story homes with slab construction and more fixtures push toward the top. We quote a flat price after an on-site assessment, so you know the number before we start.
How long does repiping take in Tupelo Mississippi?
A typical Tupelo repipe takes two to four working days. Single-story homes on a crawlspace often finish in two days. Two-story homes with attic runs and more fixtures take three to four. You will have water back on each evening, and we pressure-test before any drywall goes back up. We schedule the job so you are not without water for more than a normal workday.
Is repiping worth it in Tupelo?
Yes, if your home still has galvanized steel or polybutylene pipe and you have had two or more leaks in the past year. At that point, repair costs start stacking up faster than a repipe. New PEX or copper also restores water pressure, ends rust-colored water, and removes a known issue that buyers and home inspectors flag in Lee County. Most homeowners see the value within the first year.
Do you use PEX or copper for repiping in Tupelo MS?
We install both, and the right choice depends on your house. PEX piping is faster to install, handles Tupelo's freeze-thaw swings well, and costs less. Copper piping lasts longer in certain water conditions and some homeowners prefer it for resale. We check your water chemistry and framing, then recommend one. You make the final call, and we install either to Uniform Plumbing Code standards.
Can I stay in my home during a repipe?
Yes, you can stay in your home during a repipe. Water is shut off during working hours and restored each evening on most jobs, so you have running water overnight.
Does repiping increase home value?
Yes, repiping increases home value and resale appeal on homes with galvanized or polybutylene supply lines. New PEX or copper removes a common inspection flag and an insurance objection.
Does repiping include drywall repair?
Yes, our repipes include patching the access openings. Openings are cut small at planned points and patched before we leave; final paint matching is usually left to the homeowner or painter.
Related services
Other Services That Pair With a Repipe
Emergency Plumbing
A burst pipe at 2 a.m. does not wait for business hours. We handle emergency plumbing across Tupelo, and if the burst is the last straw on old pipe, we can schedule your repipe while we are already on site.
Residential Plumbing
Repiping is the biggest residential plumbing job most homeowners ever book. We handle everything else in the same visit, from shut-off valves to supply lines, so your whole system is brought up to date at once.
Commercial Plumbing
We repipe small commercial buildings in downtown Tupelo, including offices and rental units. If your building has recurring leaks, a commercial repipe stops the repair cycle and keeps tenants from calling after hours.Ready when you are
Get Your Repiping Tupelo MS Quote Today
One call gets a licensed plumber to your door with a flat price and a start date. We have been repiping Tupelo homes for more than 25 years, and we back the work with a workmanship warranty. Call (662) 550-8327 and let us put new pipe in your house.
Talk with the local team
Request Repiping
Call (662) 550-8327 to reach a live dispatcher. We answer 24/7 for emergencies and book same-day appointments Monday through Friday. If you prefer email, send your address and a description of the problem to info@tupelomsplumbing.com and we will reply with an arrival window.